Re: [cobalt-users] single user mode question

[brendan@xxxxxxxxxxxxx]

Thanks Bruce,

I didn't have the Terminal setting on 115200, that did the trick.

Brendan

>> I'm trying to connect to my Raq 550 in single user mode but I can't
>> seem to get it working. I'm trying to communicate from COM1 on my
>> laptop but it's almost as if the 550 doesn't see anything connected to
>> it's primary serial port when I reboot it.
>
> Are you sure you're using the primary serial port?  And is your laptop
> set to  use 115200 N-8-1?
>
>> Boot Single Mode:
>> If you boot with the serial console attached, you can hit space to
>> enter the ROM setup. You can then use the following commands: boot
>> set_params single bfd and you will get single user mode TOP
>
> Press spacebar as soon as you see any text on your laptop (assumes RaQ
> serial  port is active and bps is set properly).  Then type "boot" at
> the prompt and  press Enter, then "set_params single" and Enter, then
> "bfd" and Enter.
>
> _____________________________________
> cobalt-users mailing list
> cobalt-users@xxxxxxxxxxxxxxx
> To subscribe/unsubscribe, or to SEARCH THE ARCHIVES, go to:
> http://list.cobalt.com/mailman/listinfo/cobalt-users