Re: [cobalt-users] single user mode question

[Bruce Timberlake <bruce@xxxxxxxxxx>]

> I'm trying to connect to my Raq 550 in single user mode but I can't seem
> to get it working. I'm trying to communicate from COM1 on my laptop but
> it's almost as if the 550 doesn't see anything connected to it's primary
> serial port when I reboot it.

Are you sure you're using the primary serial port?  And is your laptop set to 
use 115200 N-8-1?

> Boot Single Mode:
> If you boot with the serial console attached, you can hit space to enter
> the ROM setup. You can then use the following commands: boot set_params
> single bfd and you will get single user mode TOP

Press spacebar as soon as you see any text on your laptop (assumes RaQ serial 
port is active and bps is set properly).  Then type "boot" at the prompt and 
press Enter, then "set_params single" and Enter, then "bfd" and Enter.