[cobalt-users] [Raq3] LCD panel controls not working

[space cookie <space_biscuit@xxxxxxxxx>]

Hello,

I can't seem to get the LCD panel controls on my RaQ3i
unit to work.  I would like to reset the primary IP#,
netmask# and gateway# settings, but I can't seem to
save these settings and get them to stick.

I also cannot reach the unit through the network port,
hooked up to my LAN network hub.  The only access I
have right now is through the serial port on the back
and PC terminal emmulation software.

Part of my problem may be that DNS may confused on my
W2000 Pro machine, as I have a modem and a NIC card
installed.  I'm not sure how to make sure that the
web-browser uses the NIC interface to reach the RaQ
unit, rather than the modem when it's not connected..

Any helpful hints would be greatly appreciated.  I'd
like to avoid a total restore from the restore CD, but
the unit may be too hashed at this point.  I suspect
sabotage...

~ Theo


=====
<######## SPACE BISCUIT ##########>
Office Phone : (503) 226-099 ext. 34
Home Phone : (503) 232-7394



__________________________________________________
Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail
http://personal.mail.yahoo.com/