[cobalt-users] RAQ4 startup message...

[ftr@xxxxxx]

Hello!

When I boot my RAQ4 I get this message on the serial port.
My question is:

1.   Is this normal?
2.   What can I do to fix this?



-----------------------------------------------------------
eth0: Invalid EEPROM checksum 0xd614, check settings before activating
this device!
eth0: Intel EtherExpress Pro 10/100 at 0x6200, 00:10:E0:02:34:C3, IRQ 11.
  Board assembly 000000-000, Physical connectors present:
  Primary interface chip None PHY #0.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0xdbd8681d).
  Receiver lock-up workaround activated.
eth1: Invalid EEPROM checksum 0x4313, check settings before activating
this device!
eth1: Intel EtherExpress Pro 10/100 at 0x6240, 00:10:E0:02:33:30, IRQ 10.
  Board assembly 000000-000, Physical connectors present:
  Primary interface chip None PHY #0.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0xdbd8681d).
  Receiver lock-up workaround activated.


-----------------------------------------------------------
Best Regards
NSN AS
Fabian Roan

OBS, NYTT TELEFON OG FAX NUMMER:
Telefon: +47 22 93 67 10
Telefax: +47 22 93 67 11 + 12
Mobil:   +47 90 63 38 83