[cobalt-users] RaQ4>Invalid Checksum, server freezed.

[Emilio Saldana <emilio@xxxxxxxxxxxxxxx>]

Hello all,

I have a RaQ4 and it sudenly freezes for no aparent reason, if I reboot
the server it will respond again.

It is the forth server we have switched for the same problem, although
we have more raq servers connected to the same switch and
they are up and running. I found the following error messages on
startup. Any hint?

A copy of both error messages are copied here:

--------------------------------------------
eth0: Invalid EEPROM checksum 0x58c5, check settings before activating
this device!
eth0: Intel EtherExpress Pro 10/100 at 0x6200, 00:10:E0:01:E5:46, IRQ
11.
  Board assembly 000000-000, Physical connectors present:
  Primary interface chip None PHY #0.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0xdbd8681d).
  Receiver lock-up workaround activated.
eth1: Invalid EEPROM checksum 0x53ca, check settings before activating
this device!
eth1: Intel EtherExpress Pro 10/100 at 0x6240, 00:10:E0:01:EA:41, IRQ
10.
  Board assembly 000000-000, Physical connectors present:
  Primary interface chip None PHY #0.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0xdbd8681d).
  Receiver lock-up workaround activated.

Cobalt Networks Bandwidth Limiting Module
Copyright (c) 1999, Cobalt Networks, Inc.
All rights reserved
portmap: RPC call returned error 111
RPC: task of released request still queued!
RPC: (task is on xprt_pending)
portmap: RPC call returned error 111
RPC: task of released request still queued!
RPC: (task is on xprt_pending)
lockd_up: makesock failed, error=-111
portmap: RPC call returned error 111
RPC: task of released request still queued!
RPC: (task is on xprt_pending)
--
Emilio Saldana
Director General,
ADigital Mexico
http://adigital.com.mx/