Re: [cobalt-users] Total Newbie, please be patient...

["Gerald Waugh" <gerald@xxxxxxxxx>]

Jay Patterson  Wrote
ON; Thursday, March 30, 2000 10:25 PM

When I put in the cablemodem IP address in the primary IP,  subnet mask and
gateway in, I could not access the RaQ3i anymore.  I tried the secondary
ethernet port, no luck, then I tried hooking up both the internal and external
network and had no luck at all.

My questions are, 1) is there any difference between the two ethernet ports on
the RaQ3i, and if so, what?

Did you configure DNS?
The 1st ethernet port is the correct one to connect to the cable modem. Page 4
#10. In the GUI you can set the IP for the 2nd ethernet Port

 There is no documentation on it, 2) are there any special considerations with
the cablemodem (no, its not DHCP, I have a static IP),  and 3) are there any
consultants in the Toronto area familiar with the RaQ3i who want to make a few
bucks helping me get this thing up and running???

How are you trying to access it?
Are you on a hub with it? (cable modem, RaQ3i, you all on the same hub)

Thanks folks,
Jay