RE: [cobalt-users] Modem Dial-on-demand

["Bob Kirk" <rfkirk@xxxxxxxx>]

Have you gone into setup via the admin, and checks out Network settings,
Modem?

If not, there is a check box there for Connection mode (Not used, Dial on
Demand, and always connected) my guess would be that you need to change the
connection mode to dial on demand from always connected.

Bob Kirk

> -----Original Message-----
> From: cobalt-users-admin@xxxxxxxxxxxxxxx
> [mailto:cobalt-users-admin@xxxxxxxxxxxxxxx]On Behalf Of Michael Paci
> Sent: Monday, February 14, 2000 12:46 PM
> To: cobalt-users@xxxxxxxxxxxxxxx
> Subject: [cobalt-users] Modem Dial-on-demand
>
>
> I have a Qube2 setup for a client. While they anxiously await the
> install of
> their DSL line, I set them up to share a 56K dial-up. The problem is, the
> Qube dials up and never hangs up. All of the machines in the office are
> turned off and the modem never hangs up. Even when I cycle the
> power on the
> modem, it dials right back in.
>
> Needless to say, the most recent bill from the ISP was ~$800. The
> phone bill
> shouldn't be too bad. I hope.
>
> What would be causing this to dial even when the Qube is the only device
> active on the network?
>
> Best regards,
>
> Mike Paci
> mjpaci@xxxxxxxxxxxxxxx
>
>
> _______________________________________________
> cobalt-users mailing list
> cobalt-users@xxxxxxxxxxxxxxx
> http://list.cobalt.com/mailman/listinfo/cobalt-users
>