Re: [cobalt-users] Re: RaQ3 - Installing a RaQ1 HD in a RaQ3

["The IOLS Team \(www.iols.net\)" <info@xxxxxxxx>]

I've tried this (Once booted you should be able to fsck and
mount /dev/hdb1, /dev/hdb3 and /dev/hdb4.) and I've receive
this message for each described above...

[root@ds3 /]# mount hdb1
mount: can't find hdb1 in /etc/fstab or /etc/mtab

Any suggestions and extremely helpful.

Sincerely,
Marty
The IOLS Team - info@xxxxxxxx
Inet OnLine Services (IOLS)
----- Original Message -----
From: "Will DeHaan" <will@xxxxxxxxxx>
To: <cobalt-users@xxxxxxxxxxxxxxx>
Sent: Friday, January 21, 2000 5:37 PM
Subject: Re: [cobalt-users] Re: RaQ3 - Installing a RaQ1 HD
in a RaQ3


| The hard disk from your RaQ can be connected to any linux
PC that has a
| spare IDE connection.  On the RaQ 3, you'll need an IDE
cable with three
| connectors in place of the existing cable.  Change the
jumper on your
| old RaQ hard disk from Master to Slave, connect the 3
connector cable to
| both drives and the logic board.  Once booted you should
be able to fsck
| and mount /dev/hdb1, /dev/hdb3 and /dev/hdb4.
|
| I'd connect the drive only long enough to recover data
before marking it
| bad and disposing of it.
|
|
| -- Will
|
| "The IOLS Team (www.iols.net)" wrote:
| >
| > Is it possible to install a HD from a RaQ on a RaQ3 and
pull
| > the data (Web sites) off it?
| >
| > I had a RaQ Crash but it appears that only a small
portion
| > of the HD is corrupt.  I'm hoping to get the web sites
off
| > there. Is this possible?
| >
| > Sincerely,
| >  Marty
| > The IOLS Team - info@xxxxxxxx
| > Inet OnLine Services (IOLS)
| > http://www.iols.net & http://www.iols.com
| > Internet Access & Services
| > ----------