RE: [cobalt-users] *** HALT **** Error on Control Station Load

["Rick G" <eklists@xxxxxxxxxxxxxxx>]

It was Bad RAM ! I replaced the RAM with new sticks and it loaded up fine.
Go figure...thanks for the tips !

Eric

> -----Original Message-----
> From: cobalt-users-admin@xxxxxxxxxxxxxxx
> [mailto:cobalt-users-admin@xxxxxxxxxxxxxxx]On Behalf Of Cobalt Supply
> Sent: Monday, May 12, 2003 3:50 PM
> To: cobalt-users@xxxxxxxxxxxxxxx
> Subject: RE: [cobalt-users] *** HALT **** Error on Control Station Load
>
>
>
> +> > I just did a clean Control Station Load with a Raq 4i with
> +> > Dual 20GB HD - It
> +> > did the entire load of packages and then stopped with
> +> > ****HALT**** Found:
> +> > CPIO: on the display.
> +>
> +> Are the drives on separate cables and both set to master?
> +
> +Yes, seperate cables and master - both were "found" on boot when
> +viewing the
> +console.
> +>
> +> How much memory is installed?
> +
> +512MB
> +
> First thing I do when I start having 'issues' with an OS reload is to
> 'reset' the CMOS by holding down the 'e' button during boot until it gives
> you the message that the CMOS has been reset then power down, don't let go
> of the 'e' button until it's powered down. Then reboot and try to
> load your
> OS again.
>
> ---
> Brad Galbraith
> Cobalt Servers & Parts
> www.cobaltsupply.com
>
> _____________________________________
> cobalt-users mailing list
> cobalt-users@xxxxxxxxxxxxxxx
> To subscribe/unsubscribe, or to SEARCH THE ARCHIVES, go to:
> http://list.cobalt.com/mailman/listinfo/cobalt-users
>