RE: [cobalt-users] OSRCD for Raq 4r not working on Raq 4i

["Tolentino, Elmer" <etolentino@xxxxxxxxx>]

> > If it stays on checking disk,
> > power down
> > press and hold the 'E' key power up and wait till it says
> > "CMOS RESTORED"
> > 
> Did that and still no go...
> 
> It says that there is a failed hard disk.  The suspected 
> drive, I am doing a full OS Restore with the 4i CD to see if 
> it loads properly and boots up.  
> 
> The two drive is RAID1 config always had a checking disk 
> delay during bootup.  It would not boot up when I had this 
> drive plugged in by itself.  The other drive plugged in by 
> itself is working fine.
> 
> RAID was detecting left drive was bad.  Is there a way to 
> diagnose if it really is bad.
> 
> If the OS restore on the 4i CD works fine with the suspect 
> bad drive, does that mean that the drive is really bad or 4i 
> with 4r OSRCD loaded does not work with RAID 1 config.  Or is 
> there another ROM I could load to make it work properly.
> 
I reloaded the OSRCD 4i on the suspect bad drive and it boots up fine without hanging on checking disk.  I do not think the RAID 1 was functioning properly with 2 drives and the OSRCD 4r loaded on the system.  I am running out of things to try.  I think that both drives are good.

Thanks,
Elmer

> > Gerald
> > -- 
> > http://frontstreetnetworks.com         http://raqware.com
> > Front Street Networks LLC   |  Phone: 203-785-0699
> > 229 Front Street, Ste C, New Haven, CT 06513-3203
> > 
> > _____________________________________
> > cobalt-users mailing list
> > cobalt-users@xxxxxxxxxxxxxxx
> > To subscribe/unsubscribe, or to SEARCH THE ARCHIVES, go to:
> > http://list.cobalt.com/mailman/listinfo/cobalt-users
> > 
> 
> _____________________________________
> cobalt-users mailing list
> cobalt-users@xxxxxxxxxxxxxxx
> To subscribe/unsubscribe, or to SEARCH THE ARCHIVES, go to:
> http://list.cobalt.com/mailman/listinfo/cobalt-users
>