RE: [cobalt-users] OSRCD for Raq 4r not working on Raq 4i

["Tolentino, Elmer" <etolentino@xxxxxxxxx>]

> 
> If it stays on checking disk,
> power down
> press and hold the 'E' key power up and wait till it says
> "CMOS RESTORED"
> 
Did that and still no go...

It says that there is a failed hard disk.  The suspected drive, I am doing a full OS Restore with the 4i CD to see if it loads properly and boots up.  

The two drive is RAID1 config always had a checking disk delay during bootup.  It would not boot up when I had this drive plugged in by itself.  The other drive plugged in by itself is working fine.

RAID was detecting left drive was bad.  Is there a way to diagnose if it really is bad.

If the OS restore on the 4i CD works fine with the suspect bad drive, does that mean that the drive is really bad or 4i with 4r OSRCD loaded does not work with RAID 1 config.  Or is there another ROM I could load to make it work properly.

Thanks,
Elmer

> Gerald
> -- 
> http://frontstreetnetworks.com         http://raqware.com
> Front Street Networks LLC   |  Phone: 203-785-0699
> 229 Front Street, Ste C, New Haven, CT 06513-3203
> 
> _____________________________________
> cobalt-users mailing list
> cobalt-users@xxxxxxxxxxxxxxx
> To subscribe/unsubscribe, or to SEARCH THE ARCHIVES, go to:
> http://list.cobalt.com/mailman/listinfo/cobalt-users
>