RE: [cobalt-users] OSRCD for Raq 4r not working on Raq 4i

["Tolentino, Elmer" <etolentino@xxxxxxxxx>]

Thanks Gerald.  I do not know know which ROM version.  Any way to find out without booting into ROM cause I do not have null modem cable.

The hard drives are configured, master and slave and on separate ide cables.

Do I need to have them daisy on the same cable?

Thanks,
Elmer



> -----Original Message-----
> From: Gerald Waugh [mailto:gwaugh@xxxxxxxxxxxxxxxxxxxxxxx]
> Sent: Saturday, April 26, 2003 5:31 PM
> To: cobalt-users@xxxxxxxxxxxxxxx
> Subject: Re: [cobalt-users] OSRCD for Raq 4r not working on Raq 4i
> 
> 
> On Saturday 26 April 2003 20:15, Tolentino, Elmer wrote:
> >
> > I was wondering if there is anything special that needs to 
> be done to get a
> > Raq 4r OSRCD (downloaded fron Sun's Site) to load on a Raq 
> 4i w/2 drives. 
> > I boots from the net and the CD boots up fine detecting a 
> working network
> > card.
> >
> > It goes through the Raid Config, and verifies the spec 
> file, but then it
> > just reboots after that.  It does not load any packages.  
> It does not even
> > partition any drives and leaves everthing intact.
> >
> 1) are both drives coniged as masters?
> 2) are both drives on seperate ide cables?
> 
> If one and two are yes, then the rom may need updating.
> Which romrev are you running?
> 
> Gerald
> -- 
> http://frontstreetnetworks.com         http://raqware.com
> Front Street Networks LLC   |  Phone: 203-785-0699
> 229 Front Street, Ste C, New Haven, CT 06513-3203
> 
> _____________________________________
> cobalt-users mailing list
> cobalt-users@xxxxxxxxxxxxxxx
> To subscribe/unsubscribe, or to SEARCH THE ARCHIVES, go to:
> http://list.cobalt.com/mailman/listinfo/cobalt-users
>