RE: [cobalt-users] /var/run/named.pid - problem

[Jake COLE <jcole@xxxxxxxxxxx>]

I have just done a manual mail send ... see transcript below:

250 2.1.0 jcole@xxxxxxxxxxxxxx Sender ok
250 2.1.5 sales@xxxxxxxxxxxxxx Recipient ok
354 Enter mail, end with "." on a line by itself
250 2.0.0 g9HCwOW07557 Message accepted for delivery

... now either I got your domain wrong, or it works fine.

The error from the log (SMTP error) ... was this during the
reception of the email in question 'sales@...' or the sending?

J.

At 01:23 PM 10/17/2002 +0100, you wrote:


> > Is the POP before SMTP enabled ?
> >
> > We had similar problems on a Raq4 while this was enabled (even
> > with clients
> > doing pop before smtp)..
> > we disabled, and all was fine again.
> >
> > no idea why this was happening.
>
>
> This is not when the client is collecting e-mail via POP, it is INCOMING
> SMTP mail to the domain.
> SMTP needs no authentication only collection via POP (and subsequent SMTP
> sending) if POP before relay enabled.
> We do not offer dial-up service so clients send outgoing e-mail through
> thier own ISP SMTP server not ours.
> We only store e-mail and offer collection via POP3.
>
> It would be nice to be able to see the mail on the server but it is not
> getting that far !!!
>
>
> Paul.
>
> _____________________________________
> cobalt-users mailing list
> cobalt-users@xxxxxxxxxxxxxxx
> To subscribe/unsubscribe, or to SEARCH THE ARCHIVES, go to:
> http://list.cobalt.com/mailman/listinfo/cobalt-users