[cobalt-users] Lost web interface w/ raq4

[Jim Dory <engineer@xxxxxxxxxxxxx>]

Pardon me if this is oft discussed but I did search the knowledgebase, 
the forum, and the user list for a couple keywords and didn't find 
anything pertaining to my problem. Not to say I didn't miss it.

I'm a complete novice to linux and Cobalts.

I can not log onto my Raq4r with the web browser anymore.
I have a Watchguard firewall and two raqs, one on DMZ which I can access 
via the web interface and one on trusted eth of firewll that I cannot.

I can log on via telnet (from same network).

I restarted and got this (dmesg):

Linux version 2.2.16C32_III (root@xxxxxxxxxxxxxx) (gcc version 
egcs-2.91.66 1999
0314/Linux (egcs-1.1.2 release)) #1 Fri Nov 9 21:54:54 PST 2001
<snip>
Receiver lock-up workaround activated.
eth1: Invalid EEPROM checksum 0x5c2c, check settings before activating 
this devi
ce!
eth1: Intel PCI EtherExpress Pro100 82559ER, 00:10:E0:03:4C:48, I/O at 
0x6240, I
RQ 10.
 Board assembly 000000-000, Physical connectors present:
 Primary interface chip None PHY #0.
 General self-test: passed.
 Serial sub-system self-test: passed.
 Internal registers self-test: passed.
 ROM checksum self-test: passed (0xdbd8681d).
 Receiver lock-up workaround activated.
portmap: RPC call returned error 111
RPC: task of released request still queued!
RPC: (task is on xprt_pending)
portmap: RPC call returned error 111
RPC: task of released request still queued!
RPC: (task is on xprt_pending)
lockd_up: makesock failed, error=-111
portmap: RPC call returned error 111
RPC: task of released request still queued!
RPC: (task is on xprt_pending)

when I do a httpd restart I get error messages of the srm.conf file 
about syntax errors or module not loaded for line #xx regarding: UserDir
and when I comment that out and try again it keeps on going down the 
listwith other errors. I've never edited that file.

I do have webmin running fine, and Samba enabled with Swat running fine. 
Just not the Cobalt web interface. (I'm using this server primarily as a 
file share server and the other raq as an email/web server.

I got some mail when I logged on via telnet stating that  (on Sunday) 
the root partition was full and then immediately following that a mail 
message stating that the web server is down and not responding, try 
rebooting or call Support, etc. The reason the root partition was full 
is because I tried creating a directory per samba instructions in that 
partition and filled it up. I've since moved that directory out of the 
root partition and into the home partition where it belongs, leaving the 
root partition at 76% full. I don't work on the weekends so not sure 
what prompted this Sunday mail.

So can someone help me trouble shoot this thing? I would greatly 
appreciate it.
I don't recall doing anything in particular that would mess things up, 
but maybe I did.

Cheers,

--
Jim D.