RE: [cobalt-users] RaQ problems

["Andy Brown" <andy.brown@xxxxxxxxxxxxx>]

<snip>
> Block bitmap differences
> 
> Free blocks count wrong for group #123
> 
> eth0: Invalid EEPROM checksum 0x40ab, check settings before 
> activating this device!
> 
> Shutting down NFS lockd: ERROR!
> Shutting down NFS statd: ERROR!
> 
> kmem_free: Bad obj addr (objp=df3ebcc0, name=vm_area_struct)
</snip>

I've not done a load of one sytem onto old hardware like you've done,
but just as a baseline my Raq3i's report similar errors from time to
time. The ones that I DO get are:
> eth0: Invalid EEPROM checksum 0x40ab, check settings before 
> activating this device!
And the
> Shutting down NFS lockd: ERROR!
> Shutting down NFS statd: ERROR!
Errors (although all of these happen only at boot-up time)

After that I rarely get another message out the serial console.
I suspect it may be due to the slightly differing age of the hardware
that's causing these problems, or indeed a possible hard-drive problem
about to surface. 

Have you fsck'd manually?? Just to find out what it reports and let you
choose how to repair.

Regards,

Andy
andy@xxxxxxxxxxxxxxxxxxxxx
HOWTO's PKGs and info --> http://www.raqpak.com/ <-- for Qube and Raq