[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[cobalt-users] How do I set my eth0 to 10mbs half-duplex on a Qube 3?
- Subject: [cobalt-users] How do I set my eth0 to 10mbs half-duplex on a Qube 3?
- From: Gregz <greg@xxxxxxxxxx>
- Date: Mon Feb 2 07:17:01 2004
- Organization: www.tplace.org
- List-id: Mailing list for users to share thoughts on Sun Cobalt products. <cobalt-users.list.cobalt.com>
I guess I won't get any answers to the quoted question below, so here's
a new one. I am the "lucky" owner of a Linksys WRT54G router and it
seams that it has some problems with some 100Mb/s full-duplex wired
links (see: http://dslrcs.clanspace.com/forum/remark,8898618~mode=flat
<http://dslrcs.clanspace.com/forum/remark,8898618%7Emode=flat>).
How do I set my eth0 to 10mbs half-duplex on a Qube 3?
Regards,
Gregs
Gregz wrote before:
Do any of you guru's and/or wizards know of (GPL) BBS / Forum software
(written in PHP) that use PAM security?
--
http://www.tplace.org/
Any e-mail messages from Gregz are given in good faith but shall not be
binding nor shall they be construed as constituting any obligation on
the part of the author of this e-mail.