RE: [cobalt-users] OSRCD for Raq 4r not working on Raq 4i

["Tolentino, Elmer" <etolentino@xxxxxxxxx>]

> You might try building a new OSRCD,
> Did you check the MD5sum
> 
> Bruce is correct, when you have trouble like this the console
> output is invaluable.
> If you don't have a null modem cable or adapter , get one.

Thanks, I built another one already and still no go.  I am plugged in
the console and from what I notices was that there was a bad superblocks
in the raid and it was stuck on rebuilding, but it was 4 hours of trying
to rebuild and there errors were that it was unrecoverable.  So I did an
OS Restore with OSRCD 4i on one of the drives.

The drive that it was trying to build the mirrored config, I tried to
install by itself on the primary controller but it was even able to
create a partition using the OSRCD 4i like it use to.  It also detected
that it was hdb even though it was set for master and is the only drive
plugged in.

When I have 2 drives plugged in, Raq 4i is recognizing as "hda" and
"hdd".  They are both set to master and I thought it should say "hda"
and "hdc".  I tried to search for instructions so that I could wipe
clean any configurations to default and wipe the 2 drives clean so that
plugging both of then in, it detects "hda" and "hdc".  And then assuming
that the drives are clean, the OSRCD 4r should work.

Thanks in advance.

Elmer

> Gerald
> --
> http://frontstreetnetworks.com         http://raqware.com
> Front Street Networks LLC   |  Phone: 203-785-0699
> 229 Front Street, Ste C, New Haven, CT 06513-3203
> 
> _____________________________________
> cobalt-users mailing list
> cobalt-users@xxxxxxxxxxxxxxx
> To subscribe/unsubscribe, or to SEARCH THE ARCHIVES, go to:
> http://list.cobalt.com/mailman/listinfo/cobalt-users