Re: [cobalt-users] every added domain on wrong interface

[Gerald Waugh <gwaugh@xxxxxxxxxxxxxxxxxxxxxxx>]

On Thu, 10 Apr 2003, Josh Kuperman wrote:

> I solved the immediate problem when, I realized after issuing an
> netstat -nr command that I had an invalid route.
>
> As best I can tell my problems came about as follows:
>
> I set up my private network, the 192.168.1.x space, on eth0 or Network
> 1. I set up my, exposed to the world network on eth1 or Network2. My
> private network settings were IP-192.168.1.1 and
> Netmast-255.255.255.0. My exposed to the public settings, for my first
> registered domain were, using the fake numbers from below, IP-
> 1.2.3.194 Netmask-255.255.255.240.
>
> So later when I added another subdomain to my DNS and created
> 1.2.3.195, instead of it being aliased as eth1:0, it was aliased as
> eth0:0. It took the netmask from the other eth0 ip. This created a
> 1.2.3.0/24 network that was added to the routing table. I manually
> deleted the insane route which means I can now access legitimate sites
> on other networks like 1.2.3.71.
>
> So, where is the documentation that I missed that says everytime you
> add a site it goes on eth0 and not eth1? Why can't I use both, why
> can't I specify? I can't find anything much -- I did print out the
> docs and have been pouring over them honest. Can is just go in and
> change the ifcfg-eth0:0 entries to ifcfg-eth1:0 entries? Can I just go
> and swap make my network 1 and my network 2 entries?
>

  On RaQs
  eth0 is connected to the Internet.
  eth1 is connected to the Intranet.
  On Qubes it's the opposite.

Gerald
--
http://frontstreetnetworks.com | http://store.raqware.com
ICQ 229276628 | Phone: +1 203-785-0699 | FAX: +1 866-201-4625
Front Street Networks LLC,  229 Front Street, Ste. #C,
New Haven, CT. 06513-3203 United States of America