RE: [cobalt-users] RAQ4R - Boot Hang - Checking Disk....*

["Jerry Farquhar" <jerry@xxxxxxxxxxx>]

I wish that were the problem... the jumpers on the new drive are set
identical to the drive it replaces (set as master)

Jerry

-----Original Message-----
From: cobalt-users-admin@xxxxxxxxxxxxxxx
[mailto:cobalt-users-admin@xxxxxxxxxxxxxxx]On Behalf Of Paul Alcock
Sent: Tuesday, October 22, 2002 10:05 AM
To: cobalt-users@xxxxxxxxxxxxxxx
Subject: RE: [cobalt-users] RAQ4R - Boot Hang - Checking Disk....*


> working drive in it's original location and a identically imaged
> drive (100%
> bit for bit identical) installed in the failed drives location.
>
> I even went as far as to install the cloned drive in the failed drive
> location and tried to boot from it without the original working drive
> connected to the system.. still no luck.
>
> Any other ideas??
>
May be way off base, but is the replacement drive meant to be set as a
slave?
(Don't own a similar RAQ but wondered if it's that simple?)

Paul


_____________________________________
cobalt-users mailing list
cobalt-users@xxxxxxxxxxxxxxx
To subscribe/unsubscribe, or to SEARCH THE ARCHIVES, go to:
http://list.cobalt.com/mailman/listinfo/cobalt-users