Re: [cobalt-users] lease150.mfg.cob 10.0.0.150

[Peter Batenburg <peter@xxxxxxxxxx>]

Hia,

I had the same problem several times. I found out it only was a problem 
when restoring 4+ raq's.
I allways do restores using my laptop. The problem was that my laptop went 
into energy save mode, and the restore installation couldn't finish the 
restore.
It could also be a problem with you cdrom drive that goes into idle mode, 
and takes a long time to spin up again.

Regards,

Peter

At 19:09 28-11-2001 +0100, you wrote:

> Hi, everybody
>
> When restoring my raq4r everything looks fine it makes partitions,
> installing rpm, running some scripts. After some time it reboots or starting
> setting up storage, running MFG tests (?), and setting up network!? It sets
> up: lease150.mfg.cob   IP:10.0.0.150 and then it stops there.
>
> I have restored 3 times always with same result.
>
> This is not how the manual said it would be, there it said that after finish
> restoring I would get a message telling me to shut down.
>
> Anybody that can tell me what is happening?
>
> Thanks,
>
> Kai R Schantz
> euroweb as