Re: [cobalt-users] Successful Interchange Install on Raq4 (long)

[Bradley Caricofe <bcaricofe@xxxxxxxxx>]

> Now here's the hard part, some of those modules above are dependant on
> each
> other, so you'll have to cross each off the list as you go thru it, and
> kind
> of piece the puzzle together.  A few of these modules require an
> additional
> one or two modules, but the best advice I can give is read the README
> file
> for dependencies & instructions.
> 
> Generally you'll do the following on each module:
>    gzip -dc yourmodule.tar.gz | tar -xof -
> Go into the newly-created directory and type:
>    perl Makefile.PL
>    make
>    make test

I ran this command in an SSH session and made sure to cancel it just as it
tries to upgrade my perl,

perl -MCPAN -e 'install Bundle::Interchange'

It seemed to install all the necessary perl modules...this was also an
Intercahnge 4.6.5. install, I think 4.8 may have just been released, If so
I'll probably install it next week.

-Brad

__________________________________________________
Do You Yahoo!?
Make international calls for as low as $.04/minute with Yahoo! Messenger
http://phonecard.yahoo.com/