Re: [cobalt-users] New IP and old IP both work,

["Gerald Waugh" <gerald@xxxxxxxxx>]

> I changed the ip number on my RAQ1/2 and plugged it into a new port on the
> hub in a different segment.  Ok, no big, the segment leaks and I can travel
> between them to the new connection and old connection (different providers).
>
> What I am confused over is this little detail.  I changed the IP# and I am
> able to connect to the new ip number.  The box rebooted after the ip number
> change even.  I looked at control panel, and the new IP number is in place.
>
> I just pinged the name to see if the nameserver change happened, and it
> pinged fine. Cool.  except it is still pinging on the old IP number.  And on
> the new IP number.  I can ssh in on the old IP number and on the new IP
> number.  I need to reassign the ip number, so now I am at a loss.
>
If you are pinging a virtual site, then you have not changed the IP number of
the virtual sites.
You have to go into server management and edit each virtual site and change the
IP number.

If you are pinging the server "raq1.yourdomain.com" and getting the above
results.
Then take a look at the main site in server management, to insure that the main
site ip address looks OK.

Also take a look at Control Panel -> Network and make sure the General and the
Interface settings look OK.

Don't forget that when you change the IP address, you also have to change all
the DNS records.
Hope this helps!
Gerald