RE: [cobalt-users] RaQ3 Password Protect Directory Problem

[Wayne Sagar <wsagar@xxxxxxxx>]

>if you add:
>AuthPAM_Enabled off
>to the .htacecess this should get around your problem
>refer to the attached posting from Dan that also covers some FP
>complications :-)

Thanks Jim,

Where were you about an hour ago <grin>

Found the above information a few minutes ago, by throwing shoes, coffee cups, full ashtray's and whatever else I could at my keyboard, until I figured out Dan's magic formula for searching archives.. (I think it was that camel butt that did the trick:)

The info is in the archives but had not come up until the above mentioned tantrum took me deeper into the archives, far past the seeming end of relevant postings and into the neverland of messages that did not pertain and beyond into the "keep clicking the arrow past the amount of indexes shown" stage...

But it works and that project is behind me...

Thanks
Wayne