Re: [cobalt-users] How do I configure Webalizer after install ?

["Carrie Bartkowiak" <ravencarrie@xxxxxxxx>]

> I'm new to the RAQ world . I downloaded the Webalizer package from
>  http://pkg.nl.cobalt.com/i386/webalizer-1.30.04.i386.pkg
>
> What do I do next to get it running for multiple virtual sites on a
> RAQ4r ?
> Thanks,
> Tom O'Brien

Thom,
Look through it, there are some little configurations here and there you
might want to tweak and/or change.
Just install it through the GUI. It automatically sets itself up to work for
all of your sites.
After that, you can either wait for the cron job to run the first time, or
go into the cron folder and run the pl file yourself. I forget now which one
it is, check the documentation.
I installed it (RaQ4i) and then just ran the .pl file through telnet and was
able to access all of the website stats for all of the sites immediately in
the folder where I had told webalizer to put them (in the config file or the
.pl file itself).  By default I believe it puts them in domain.com/stats but
I didn't want them there.
To run a cgi through telnet (not sure if you know this) just telnet in, su
to root, go to the cron folder where the file is and type
./filename.pl
Only took a couple of seconds for me, you might have a bunch of sites so it
may take a few seconds more.

Wish I could be more specific, hope this helped though. 2:30am and I'm
falling asleep here.  :)

Carrie Bartkowiak