[cobalt-users] SNMP for Cache Raq 2

[Othmar Truniger <truniger@xxxxxxxxxx>]

Hi Cobalt user list,

I installed my first Cache RaQ yesterday and signed to this list 5 minutes ago. 
So please forgive me if this has been discussed before.

I installed the Cache RaQ out of the box using a 10BaseT port. After configuring 
and tweaking the squid.conf (I need more Squid features than offered by the 
admin interface) I moved the box to the server room hooking it up on full-duplex 
100BaseT. The 100M LED is actually solid light and the switch port also reports 
full-duplex 100Mbit/s.

Now when I use a MIB browser to scan the interface it only reports 10'000'000 
maximum speed. And also when I generate the config file for MRTG it says 
1250.0kBytes/s maximum speed. This info is obviously wrong.

What command do I use on Linux to ask the actual setting on the box itself ??
Is the MIB incorrect or is some invalid information stored somewhere ??

Where can I add the additional entry for Maintainer ??

I appreciate hints and comments on this matter

Regards, Othmar

----------------------------------------------------------------------------
Othmar Truniger        mailto:truniger@xxxxxxxxxx Mettler-Toledo GmbH
System Manager         Phone: ++41 1 944 31 61    8606 Naenikon, Switzerland
"Beyond Weighing"      FAX:   ++41 1 944 27 10    http://www.mt.com
----------------------------------------------------------------------------
"Wisdom is chasing me, but I'm faster"