Re: Fw: [cobalt-users] [Qube2] Not Reponding

[Mike Vanecek <nospam99@xxxxxxxxxxxx>]

Did you see the post from Jerry Waugh <jwaugh@xxxxxxxxxxx> - it is almost
identical to yours?

On Tue, 18 Apr 2000 17:50:55 -0400, "Gerald Waugh" <gerald@xxxxxxxxx> wrote:

:>I have a request in for Cobalt support, but while I am waiting;;;;
:> Hi,  a couple of questions!
:> (1)I have a new Qube2, I set it up, IP address, subnet mask, gateway.
:> I accessed the Qube2 and the browser displayed the setup HTML file.
:> Then I quit for the evening.
:> The next morning I could not and still cannot access the Qube2.
:> I tried rebooting, the LCD displays all the proper boot messages and then
:> displays the IP address.
:> Does anyone have any idea what happened?

Did you set any IP filters that could conflict? If so, they can be cleared
from the LCD control. Have your retried resetting the network configuration
from the LCD panel (see Appendix A in the Qube2 manual for instructions).

:> (2) I think that you are supposed to be able to access the Qube2 through a
:>serial
:>port, has anyone done this?
:>Gerald

Maybe this earlier post will give you some ideas?

On Wed, 15 Mar 2000 14:36:32 -0800, "Byron C. Servies" <bservies@xxxxxxxxxx>
wrote:

:>Hi there!
:>
:>Recently I discovered that my portable's terminal program wouldn't allow me to set
:>the speed to 115kb/s, which is required for the boot-time diagnostics from the
:>Qube2 serial port.  I have found a very handy solution and thought I would pass it
:>along.
:>
:>Using the standard Palm "modem" cable:
:>
:><http://www.palm.com/support/helpnotes/hardware/modemcbl.html>
:>
:>and a teminal program, for instance:
:>
:><http://www.markspace.com/online.html>
:>
:>you can plug your palm right into the box and capture the output to a timestamped
:>memo.  Very handy, I find: no 9-pin gender changers or anything.
:>
:>Byron
:>