[cobalt-users] RaQ2 display shows the IP address of 0.0.0.0 after a reboot

["Jason Nickel" <jason@xxxxxx>]

After a power outage that lasted longer than our UPS our RaQ2 went down and came back
partially dead.  The ip address listed on the display was listed as 0.0.0.0.  I tried
re-entering a the IP address and gateway etc. but it wouldnt take it.

After connecting a serial interface to the RaQ I was able to manually set the IP address
to eth0 and setup the routes however if the server is rebooted all of the settings are
reset back to 0.0.0.0

Can someone please help me.

Thanks

--
Jason Nickel (aka Sputnik)
jason@xxxxxxxxxxxx