[cobalt-developers] Re: installing the Cold Fusion software onto the RAQ Vol 1 #435 - 18 msgs

["Colm Brazel" <cbweb@xxxxxx>]

--->Message: 5
>Date: Wed, 3 Jan 2001 12:45:28 -0800 (PST)
>From: Brian Porter <bporter@xxxxxxxxx>
>To: cobalt-developers@xxxxxxxxxxxxxxx
>Reply-To: bporter@xxxxxxxxx
>Subject: [cobalt-developers] RAQ 4i with Cold Fusion
>
>I have purchased the 4.5.1 version of Cold Fusion for Linux.  We received
the CD and now we are in a bind.  We would like to know the procedure for
installing the Cold Fusion software onto the RAQ.  We are having problems
since the install directions that CF supplies is for servers with a CD-ROM
drive on them.  Any assistance would be greatly appreciated.
>
>Thanks In Advance
>
--Original Message-----
From: cobalt-developers-request@xxxxxxxxxxxxxxx
<cobalt-developers-request@xxxxxxxxxxxxxxx>
To: cobalt-developers@xxxxxxxxxxxxxxx <cobalt-developers@xxxxxxxxxxxxxxx>
Date: Friday, January 05, 2001 8:11 PM
Subject: cobalt-developers digest, Vol 1 #435 - 18 msgs


Hi,

Lots of developers seem to be having this problem, including myself and
quite a few have held off getting a raq because of it. Most I could find out
was from an Allaire consultant who said they were talking to Cobalt on this.
What Cobalt have to decide to do is to
make a package of 4.5.1 that can be deployed on the Raq, until they do that
there is no way that I know of that it can be done remotely. But if you know
of a way to get support staff to do a local installation, please let me
know.

Regards

Colm

Colm (Brazel)MA
CB Publications
Internet www.cbweb.net
E-mail cbweb@xxxxxxxxx
cbweb@xxxxxx