Re: [cobalt-developers] Automatically loading SCSI driver on Qube2?

[Jakob Strebel <jstrebel@xxxxxxxxxxxxxxxxx>]

Byron,
I am also using the 2930U. Initially I had the same symptoms, the kernel 
did not recognize the SCSI card

after the upgrade to the experimental Kernel, my Qube2 is working with my 
tape drive. (Thanks to Tim Hockin from Cobalt)


ftp://ftp.cobaltnet.com/pub/experimental

the files are:
        kernel-2.0.34C53_SK-3.mips.rpm
        kernel-headers-2.0.34C53_SK-3.mips.rpm
        kernel-source-2.0.34C53_SK-3.mips.rpm

Hope this helps
jakob

At 11:31 07.06.00 -0700, you wrote:
> Hi,
>
> I now feel like a complete idiot: I have a modified aic7xxx driver that 
> works with
> an Adaptec 2930U SCSI card, but I can't get it to load at boot time.  I 
> have tried
> a couple of things with /etc/conf.modules and currently have the lines:
>
>         alias scsi_hostadapter aic7xxx
>         install scsi_hostadapter modprobe scsi_hostadapter
>
> but when I boot the system I get a message like:
>
>         scsi: 0 hosts
>
> and the driver doesn't load.  After the qube2 boots I can run modprobe and it
> loads just fine.
>
> Anybody know what I am doing wrong?
>
>
> Thanks,
>
> Byron
>
>
>
> _______________________________________________
> cobalt-developers mailing list
> cobalt-developers@xxxxxxxxxxxxxxx
> http://list.cobalt.com/mailman/listinfo/cobalt-developers