[cobalt-developers] qube2, PCI serial port

[Matthew Williams <williams@xxxxxxxxxxxx>]

We're trying to get a SIIG Cyber I/O card (1P, 1S) working
on our qube 2 running 2.0.34C53.  The parallel port works fine
(polling mode) but we can't get bits in or out from the serial
port.  I recompiled pciserial.c with the various debugging messages
turned on and we are getting into the transmit routines at the
approprite times, i.e. after keypresses in minicom, but no bits
come out and we never show incoming bits in the interrupt routines.

We do have +/- 11 volts on the various DB-9 pins, and DTR _does_ 
change state when minicom is started and stopped.

Any thoughts or suggestions?

Thanks.

Matt
-- 
+-------------------------------------------------------------+
                  No Mommy, say _shoot_.
                               Alexandra, 4

Matthew Williams                       Mack Information Systems
215-884-8123 x. 207 voice                      One North Avenue
215-886-5030 fax                          Wyncote, PA 19095 USA